News
&Nbsp;   processing of tapping machine FAQ:
    precision tap expanded the selected anomalies anomaly cause countermeasure for inappropriate use of precision series of taps that cutting bevel cutting the length of plug use spiral pointed tap reduction or spiral tap tap number of chip, and chip with volumes increased. Use a fine thread. Maximize of bottom. Blind hole threads, bottom hole deepens. Shorten the tapping length. Instead he kinds of cutting oil and grease. Conditions of use do not adjust the cutting speed. Under the prevention of tap and hole eccentric or oblique. Tap or toolholder from fixed to floating. Feed rate should be appropriate and prevent tooth type Variant. Rigid tapping the appropriate selection of tapping machine of processing capacity. To prevent vibration. Sticking to the knife using a surface oxide film of oil taps use high cutting resistance to bond. Reduce cutting speed. Changing the cutting angle suitable for cutting material. Tap Grinding without the appropriate chip Groove should be uniform. Cutting angle and ate into the clearance angle not too large. Blade back, not too small. Remove grinding burrs.
reduced tap selection was not appropriate use of more taps. To cut wood in the case of copper alloys, aluminum, cast iron, such as tapping the expansion rate less. Cutting materials such as tubular or sheet easier to rebound. Bevel angle appropriately. Increase the cutting angle. Traumatic turn of the thread exits, especially grain pattern within the taps will leave the air inlet, speed should be appropriate so as to avoid injury. There are chips in rifled residual grinding taps, reducing its chips remain. After complete removal of chips only to gauge to check.
surface cracks or bite marks cutting length is not enough to increase cutting length in the front. Improper cutting angle cutting angle must be compatible with the material. Sticking to the knife using tap to some processing by grinding. Reduced thickness of the blade. Use of surface treated taps. Changing cutting oil type